Want to try out the new X Sleeve on your existing setup? If you have ordered an X-Sleeve from us or if you have secured a section of a double walled section of your own, here are the installation instructions to get you going.

undo the clamps on the jet ski end of the hose (Speed Clamp end)

Speed Clamp flange end removed

remove previous strap from hose

to ease the telescoping of the two hose, fold the inner hose in half and tape about every 18 inches

short end of X Sleeve goes toward the end

feed through with the sewn webbing loop around the inner hose.

The sewn loop inside the X Sleeve wraps the supply hose inside the tube

the webbing loop should be about nine feet. three meters from the end of the hose.

assembled configuration

re-assemble the flange onto the end of the hose. Tighten clamps to 30 newtons per meter.